Puede manipular el tamaño de las particiones en la unidad de destino (más grande) Si va de una unidad más pequeña a una más grande, de forma predeterminada, el tamaño de la partición de destino será el mismo que el de la fuente. Seleccione TODAS las particiones en la unidad C existente This will probably require the commandline diskpart function, and the clean command.Įjecute Macrium Reflect (o Samsung Data Migration) Later, reconnect the old drive and wipe all partitions on it. Maybe reboot a time or two, just to make sure. It should boot from the new drive, just like the old drive. Swap the SATA cables around so that the new drive is connected to the same SATA port as the old drive This is to allow the system to try to boot from ONLY the SSD You can manipulate the size of the partitions on the target (larger)driveĬlick on 'Cloned Partition Properties', and you can specifiy the resulting partition size, to even include the whole thingĭisconnect ALL drives except for the new SSD If you are going from a smaller drive to a larger, by default, the target partition size will be the same as the Source. Select ALL the partitions on the existing C drive

Run the Macrium Reflect (or Samsung Data Migration) If you are cloning from a SATA drive to PCIe/NVMe, install the relevant driver for this new NVMe/PCIe drive.ĭisconnect ALL drives except the current C and the new SSD Verify the actual used space on the current drive is significantly below the size of the new SSDĭownload and install Macrium Reflect (or Samsung Data Migration, if a Samsung SSD) Specific steps for a successful clone operation:

Clone ssd macrium reflect